Vehicle Features: 

• Built in engine block heater. (Switch located in electrical cabinet)

• Built in automatic charging system  (Charge status indicator by oxygen door on the module.outside)

• 4 Wheel Anti-lock Brakes

• Dual Real Wheels

• All Season Tires

• In-Dash GPS

• Reverse Camera

• Automatic Headlights

​

Handling Dynamics:

• ABS:  Hold firm pressure in a emergency stop and keep holding, the pedal may travel to the floor.                                   Let the ABS system manage the stop.  DO NOT LET OFF THE PEDAL

• Center of Gravity:  This is a tall vehicle, turns and ramps can pose a significant risk of vehicle roll over.                                                Exercise caution with any high profile vehicle.

• Height:  (9 feet) Do not enter a Drive-Thru, or area with an awing with clearance less than 10 feet.  

• Width:   96 Inches or 8 feet wide from side to side.

• Acceleration: (2 Wheel Drive) This vehicle is equipped with a powerful Diesel engine.                                                                                    Exercise caution when on wet or slippery surfaces.                                                                                                                                         Vehicle is not equipped with a limited slip differential or traction control. 

​

Operation Basics:

• Starting:  If the vehicle is warm there is no need to wait for a glow plug light, start vehicle normally.

• Cold Starting:  Turn key to ON and wait for glow plug light to turn off, then start vehicle.

• Winter Starting:  Plug in block heater below 20 degrees, wait for glow plug light. (DO NOT USE ETHER)

• Shut Down: Allow engine to idle for approximately 60 seconds to allow the turbo to cool before shutdown.

• Cleaning DPF Filter: Refer to instructions above driver side visor.

• Tow / Haul Mode:  Use when towing any trailer.

• Powering the "mod":  Master switch on center console (lower left) powers all module systems.

• Patient heat/cool:  Patient heat cool is controlled in the patient compartment on the control panel

• Emergency Lights:  Top row center console

• Scene Lights:  Bottom row center console

• Back up alarm: Override has been disabled the switch is not connected so the alarm cannot be turned off.

• Patient Lights:  Switches located above the work counter on the control panel and lower row front console.

• On Board Suction: Switch located above the work counter as well as suction control dial.

• Inverter Control:  Inverter is automatic and controlled by the ignition key. (Inveter switch is disabled.)

• 120v AC Power:  Available when inverter is on or truck is plugged into shore power.

• Trailer Package:  Vehicle is for light duty towing, utility trailers under 4000 lbs only.

Ambulance Center Console:

​

Master: Controls all power for module accessories such as the inverter, emergency lights and module control panel.

​

Primary: All red and white flashing lights mounted to the truck, used when the vehicle is in motion running emergency.

 

Secondary:  All red lights continue to flash but all white lights are disabled as required by DOT regulations. 

​

Light Bar:  Controls the light bar ON/OFF

​

DOT Regulation:  Flashing white lights cannot be displayed when an emergency vehicle is parked.  Turn off the light bar and set Primary/Secondary to "Secondary"  when staging or parked on a roadway   ex:  vehicle crash or fire standby.

​

Flood:  Scene lights.

​

Patient Heat/Cool: Master for rear heat and AC.

​

Back up alarm override:  DISABLED